High Voltage Radial Leaded Dividers (HVD Series)

Advantages

Our patented Micropen® precision printing technology provides superior precision, thick-film radial through hole resistor dividers.

  • Voltage Ratings to 40,000 Volts
  • Resistance Values to 2 TΩ
  • Ratio Tolerances to 0.1%
  • Ultra High Stability
  • Very Low Noise
  • VCR to 0.05 ppm/V
  • TCR to 25 ppm/°C
  • TCR Tracking to 5 ppm/°C
  • Custom Configurations
HVD Series Data Sheet

HVD Electric Specs

Tolerance and value are case size dependent. Absolute tolerance is 15% unless otherwise specified.
Ratio = (R1+R2)/R2 TCR tracking is typically < 25°C ppm/°C.
For custom sizes and configurations, consult factory.

HVR Resistor Dimensions
Wire Leads:
22AWG (0.025″),
1.3″ typical lengthSpade Leads:
0.01” thick, 0.02” wide, 0.325”
minimum length, standoff 0.06” max.

HVD Case Size

Test Maximum ΔR
Short Time Overload 0.1%
Load Life 0.1%
Temperature Cycle 0.1%
Moisture Resistance 0.1%
Shock 0.05%
Vibration 0.05%
Dielectric Withstanding Voltage 0.05%
Resistance to Soldering Heat 0.05%
Parameter Typical
Operating Temperature -55°C to 150°C
TCR measured from 25°C to 75°C
Resistance Value Values > 10M are measured at 100V
for custom test voltages consult factory
Power Derating Curve

Power Derating Curve

Material Construction

Substrate- 96% Alumina

Coatings- All resistors are glass encapsulated with optional single side epoxy or powder coating.

Custom Configurations Available Upon Request

Please consult with our knowledgeable sales staff for help specifying custom parts to meet your needs.

New Project Inquiries

Name(Required)
This field is for validation purposes and should be left unchanged.